Functions > Targeted Exchange Line Access > Function Key for Targeted Exchange Line Access (A – Function Key Exchange Line)

Function Key for Targeted Exchange Line Access (A – Function Key Exchange Line)
Important: Only available for operation on the PBXs COMpact 3000 analogue/ISDN/VoIP, COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 4000, COMpact 5000/R, COMpact 5200/R, COMpact 5500R and COMmander 6000/R/RX.
Press the key to initiate targeted exchange line access. This allows you to immediately dial the external number (without an exchange line access number).
Important: If you must prefix e.g. an exchange line access number when entering/selecting a phone number, depends on the exchange line request (automatic, direct exchange line telephone, internal telephone) that was configured in the PBX (see Advanced Information of the PBX).
In addition the status of the S0 port is indicated by the corresponding LED.
 
All of the B-channels on the S0 port/bundle are in use.
At least one B-channel on the S0 port/bundle is available. Press the key to allocate the line still available.
S0 port/bundle is available. Press the key to allocate one of the available lines.
Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.
 
Proceed as follows by assigning the function key:
Note: For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
 
Configuration with COMfortel Set
 
Your own exchange lineTelephone no 
external number of the PBX which is to be transmitted at targeted exchange line access.
 
 
Configuration with the Telephone
 
Telephone no
external number of the PBX (without exchange line access number and prefix) which is to be transmitted at targeted exchange line access.

COMfortel 1200 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019