Function Key for Configuration Switchover

Functions > Configuration Switchover > Function Key for Configuration Switchover

Function Key for Configuration Switchover

Press the key for general functions while the telephone is in the idle state to open the Configuration menu. After this, you can enable the configuration.

Press the key defined for configurations to enable the configuration that has been set up.

In addition the status of the function is indicated by the corresponding LED.

LED signalling on the key (only for defined key assignment):
Green	The configuration saved in the key is enabled.
Off	The configuration saved in the key is disabled.

Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.

Requirements for operating the function:

•

At least two configurations set up in the PBX

•

Authorisation in the PBX for Configuration switching

Proceed as follows by assigning the function key:

•

Using COMfortel Set by selecting

–

–

Defined config. on

•

Using the telephone by selecting

–

Note: For further information about the general procedures when assigning function keys, see Function Keys.

Additional settings for this function key are described in the following.

Configuration with COMfortel Set

configuration to be activated

Selection of a configuration (depending on the PBX type).

Identification number

Marks the identification number of a configuration (depending on the PBX type).

Configuration with the telephone

general: Press the key to open the switch configuration menu.

defined: Press the key to enable the set configuration.

Selection of a configuration.

COMfortel 1200 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019