Functions > Call Forwarding > Switching Call Forwarding for Subscribers On/Off

Switching Call Forwarding for Subscribers On/Off
Proceed as follows:
 
Requirements:
Authorisation in the PBX for Controlling of the PBX using the telephone
 
To enable or disable call forwarding for subscribers, press the function key configured for call forwarding (subscribers).
Alternatively, proceed as described below.
1.
Press the Menu key and open the menu functions > Call fwd.:scr.
2.
deactivate all: Disables all currently enabled call forwarding for subscribers. (No other action is required.)
unconditional: Switches call forwarding unconditional for subscribers on or off.
on busy: Switches call forwarding on busy for subscribers on or off.
on no reply: Switches call forwarding on no reply for subscribers on or off.
3.
switch on: Enables call forwarding for subscribers.
switch off: Disables call forwarding for subscribers. (No other action is required.)
Note: If you press the telephone book key before entering the destination number, you can select the desired phone number from the telephone book.
4.
Important: If you must prefix e.g. an exchange line access number when entering/selecting a phone number, depends on the exchange line request (automatic, direct exchange line telephone, internal telephone) that was configured in the PBX (see Advanced Information of the PBX).

COMfortel 1200 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019