Functions > Call Forwarding > Function Key for Call Forwarding for Subscribers

Function Key for Call Forwarding for Subscribers
Press the key to enable, disable and switch call forwarding for subscribers over.
Exception: A key that is defined to disable call forwarding for subscribers only disables the currently enabled call forwarding for subscribers.
In addition the status of the function is indicated by the corresponding LED.
 
Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.
 
Requirements for operating the function:
Authorisation in the PBX for Controlling of the PBX using the telephone
 
Proceed as follows by assigning the function key:
Note: For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
 
Configuration with COMfortel Set
 
Destination of the call diversionTelephone no  
Destination number.
Note: Click to accept a phone number from the telephone book in the Telephone no entry field.
 
Destination of the call diversionType of phone number 
Marks the phone number as internal or external number.
 
 
Configuration with the Telephone
 
Telephone no
Destination number.
Note: If you press the telephone book key before entering the destination number, you can select the desired phone number from the telephone book. Alternatively, you can press a configured speed dialling key to select the destination number.
Important: If you must prefix e.g. an exchange line access number when entering/selecting a phone number, depends on the exchange line request (automatic, direct exchange line telephone, internal telephone) that was configured in the PBX (see Advanced Information of the PBX).
 
 

COMfortel 1200 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019