Functions > Call Forwarding > Function Key for Call Forwarding for External Numbers

Function Key for Call Forwarding for External Numbers
Important: Only available for operation on the PBXs COMpact 3000 analogue/ISDN/VoIP, COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 4000, COMpact 5000/R, COMpact 5200/R, COMpact 5500R and COMmander 6000/R/RX. On the other PBXs this function can be set via programming sequence (see Advanced Information of the PBX).
Pressing the key enables, disables and switches call forwarding for external numbers over.
Exception: A key defined to disable all instances of call forwarding for external numbers disables all enabled call forwarding for external numbers. The prerequisite is that function keys have been configured for these instances of call forwarding.
In addition the status of the function is indicated by the corresponding LED.
 
Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.
Important: When operating the function via the key, the success/failure of the operation is indicated by a change in colour on the LED. During the configuration in the public exchange (this takes perhaps from a few seconds up to a minute), the LED blinks yellow.
 
Requirements for operating the function:
Authorisation assigned in the PBX for Features to be configured by the network provider (CF, keypad)
 
Proceed as follows by assigning the function key:
Note: For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
 
Configuration with COMfortel Set
 
Your own exchange line Telephone no 
Own external number to be forwarded (without exchange line access number and with a area code).
 
Destination of the call diversionTelephone no  
External destination number (with exchange line access number, exception: automatic exchange line request was configured in the PBX).
Note: Click to accept a phone number from the telephone book in the Telephone no entry field.
 
Configuration 
Permanent configuration: Call forwarding unconditional for external numbers is enabled, disabled or switched over in the permanent configuration.
Current configuration: Call forwarding unconditional for external numbers is enabled, disabled or switched over only in the current configuration.
Note: Call forwarding for the current configuration can only be enabled if call forwarding for the permanent configuration is disabled.
 
 
Configuration with the Telephone
 
Phone number
External destination number (with exchange line access number, exception: automatic exchange line request was configured in the PBX).
Note: If you press the telephone book key before entering the destination number, you can select the desired phone number from the telephone book. Alternatively, you can press a configured speed dialling key to select the destination number.
 
no.to redirect
External phone number of the PBX to be forwarded (without exchange line access number and with a area code)
 
permanent config: Call forwarding for external numbers is enabled, disabled or switched over in the permanent configuration.
current conf.: Call forwarding for external numbers is enabled, disabled or switched over only in the current configuration.

COMfortel 1200 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019