Function Key for Targeted VoIP Access Point

Important: Only available for operation on the PBXs COMpact 3000 analogue/ISDN/VoIP, COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 4000, COMpact 5000/R, COMpact 5200/R, COMpact 5500R and COMmander 6000/R/RX.

Press the key to initiate a targeted VoIP access point. This allows you to immediately dial the external phone number.

Important: If you must prefix e.g. an exchange line access number when entering/selecting a phone number, depends on the exchange line request (automatic, direct exchange line telephone, internal telephone) that was configured in the PBX (see Advanced Information of the PBX).

In addition the status of the channels for the targeted VoIP access point is indicated by the corresponding LED.

LED signalling on the key:
Red	All of the channels for the VoIP access point are in use (no call possible).
Yellow	Some of the channels for the VoIP access point are in use (at least one channel for the VoIP access line is still available). Press the key to allocate the channel still available.
Off	All channels for the VoIP access point are available. Press the key to allocate an available channel.

Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.

Requirements for operating the function:

•

A configured VoIP account

Proceed as follows by assigning the function key:

•

Using COMfortel Set by selecting VoIP account

•

Using the telephone by selecting VoIP account

Note: For further information about the general procedures when assigning function keys, see Function Keys.

Additional settings for this function key are described in the following.

Configuration with COMfortel Set

Account number – Telephone no

Account number of the VoIP account

Configuration with the Telephone

Telephone no

Selection of a VoIP account.