Display of the Group Status

Important: Only available for operation on the PBXs COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 4000, COMpact 5000/R, COMpact 5200/R, COMpact 5500R and COMmander 6000/R/RX.

Press the key in the idle mode of the telephone to display the current group status of the subscribers (logged out, logged in as incoming and/or outgoing) on the LEDs of configured speed dialling keys for approx. ten seconds. For this purpose, the speed dialling keys must be assigned to the corresponding subscriber numbers. Press the key again during the ten seconds to cancel the display.

LED signalling on the key:
Yellow (blinking)	The group status is being queried.

LED signalling on the speed dialling keys assigned to subscriber numbers:
Red	The telephone is logged out of the group.
Green	The telephone is logged into the group for incoming and outgoing calls.
Yellow	The telephone is logged into the group for incoming calls.
Yellow (blinking)	The telephone is logged into the group for outgoing calls.

Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.

Requirements for operating the function:

•

Speed dialling keys assigned to the corresponding subscriber numbers

Proceed as follows by assigning the function key:

•

Using COMfortel Set by selecting Group status

•

Using the telephone by selecting Group status

Note: For further information about the general procedures when assigning function keys, see Function Keys.

Additional settings for this function key are described in the following.

Configuration with COMfortel Set

group log status – Telephone no

Phone number of the group.

Configuration with the Telephone

Telephone no

Selection of the group by its name/its number.