Functions > Relays > Function Key for Switching Relays On/Off
Function Key for Switching Relays On/Off
Important: Not available for operation on the PBX COMpact 3000 analogue/ISDN/VoIP.
Press the key to switch to the configured relay on or off or to switch it over.
In addition the status of the relay is indicated by the corresponding LED.
 
LED signalling on the key:
Green
The relay configured on the key is enabled.
Off
The relay configured on the key is disabled.
Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.
Requirements for operating the function:
•
A relay configured in the PBX with relay mode configuration dependent or PC relay
•
Authorisation in the PBX for Switching of relay
•
Operating mode Manual relay configured in the PBX.
 
Proceed as follows by assigning the function key:
•
Using COMfortel Set by selecting Relay
•
Using the telephone by selecting relay
Note: For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
 
Configuration with COMfortel Set
 
Relays to be switched 
Relay to be switched (depending on the PBX type).
 
Identification number   
Identification number of the relay to be switched (depending on the PBX type).
 
 
Configuration with the Telephone
 
Relay
Relay to be switched.
 
COMfortel 1600 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V10 02/2019