Function Key for Call Forwarding for Subscribers

Press the key to enable, disable and switch call forwarding for subscribers over.

Exception: A key that is defined to disable call forwarding for subscribers only disables the currently enabled call forwarding for subscribers.

In addition the status of the function is indicated by the corresponding LED.

LED signalling on the key (not applicable if defined with "deactivate all"):
Red	Call forwarding for subscribers is enabled for the configured destination.
Yellow	Call forwarding for subscribers is enabled for another destination.
Off	Call forwarding for subscribers is disabled.

Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.

Requirements for operating the function:

•

Authorisation in the PBX for Controlling of the PBX using the telephone

•

For external destination numbers: Authorisation assigned in the PBX for Configuring CF (sub) to ext. number

Proceed as follows by assigning the function key:

•

Using COMfortel Set by selecting

–

Subscriber CF unconditional

–

Subcriber CF on busy

–

Subcriber CF on no reply

–

Switch off all subscriber CF

•

Using the telephone by selecting

–

call fwd.:scr > deactivate all

–

call fwd.:scr > unconditional

–

call fwd.:scr > on busy

–

call fwd.:scr > on no reply

Note: For further information about the general procedures when assigning function keys, see Function Keys.

Additional settings for this function key are described in the following.

Configuration with COMfortel Set

Destination of the call diversion – Telephone no

Destination number.

Note: Click

to accept a phone number from the telephone book in the Telephone no entry field.

Destination of the call diversion – Type of phone number

Marks the phone number as internal or external number.

Configuration with the Telephone

Telephone no

Destination number.

Note: If you press the telephone book key before entering the destination number, you can select the desired phone number from the telephone book. Alternatively, you can press a configured speed dialling key to select the destination number.

Important: If you must prefix e.g. an exchange line access number when entering/selecting a phone number, depends on the exchange line request (automatic, direct exchange line telephone, internal telephone) that was configured in the PBX (see Advanced Information of the PBX).