Function Key for Call Forwarding for External Numbers

Important: Only available for operation on the PBXs COMpact 3000 analogue/ISDN/VoIP, COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 4000, COMpact 5000/R, COMpact 5200/R, COMpact 5500R and COMmander 6000/R/RX. On the other PBXs this function can be set via programming sequence (see Advanced Information of the PBX).

Pressing the key enables, disables and switches call forwarding for external numbers over.

Exception: A key defined to disable all instances of call forwarding for external numbers disables all enabled call forwarding for external numbers. The prerequisite is that function keys have been configured for these instances of call forwarding.

In addition the status of the function is indicated by the corresponding LED.

LED signalling on the key (not applicable if defined with "deactivate all"):
Red	Call forwarding for external numbers is enabled in the public exchange/PBX for the configured destination and selected configuration.
Yellow	Call forwarding on busy or on no reply for external numbers has been configured, but it is overridden by an additional call forwarding unconditional for external numbers.
Yellow	Call forwarding for external numbers is enabled in the public exchange/PBX for another destination or configuration.
Off	Call forwarding for external numbers is disabled in the public exchange/PBX.

Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.

Important: When operating the function via the key, the success/failure of the operation is indicated by a change in colour on the LED. During the configuration in the public exchange (this takes perhaps from a few seconds up to a minute), the LED blinks yellow.

Requirements for operating the function:

•

Authorisation assigned in the PBX for Features to be configured by the network provider (CF, keypad)

Proceed as follows by assigning the function key:

•

Using COMfortel Set by selecting

–

CF unconditional (MSN/DDI)

–

CF on busy (MSN/DDI)

–

CF on no reply (MSN/DDI)

–

Switch off all CF (MSN/DDI)

•

Using the telephone by selecting

–

MSN/DDI CF > deactivate all

–

MSN/DDI CF > unconditional

–

MSN/DDI CF > on busy

–

MSN/DDI CF > on no reply

Note: For further information about the general procedures when assigning function keys, see Function Keys.

Additional settings for this function key are described in the following.

Configuration with COMfortel Set

Your own exchange line – Telephone no

Own external number to be forwarded (without exchange line access number and with a area code).

Destination of the call diversion – Telephone no

External destination number (with exchange line access number, exception: automatic exchange line request was configured in the PBX).

Note: Click

to accept a phone number from the telephone book in the Telephone no entry field.

Configuration

Permanent configuration: Call forwarding unconditional for external numbers is enabled, disabled or switched over in the permanent configuration.

Current configuration: Call forwarding unconditional for external numbers is enabled, disabled or switched over only in the current configuration.

Note: Call forwarding for the current configuration can only be enabled if call forwarding for the permanent configuration is disabled.

Configuration with the Telephone

Phone number

External destination number (with exchange line access number, exception: automatic exchange line request was configured in the PBX).

Note: If you press the telephone book key before entering the destination number, you can select the desired phone number from the telephone book. Alternatively, you can press a configured speed dialling key to select the destination number.

no.to redirect

External phone number of the PBX to be forwarded (without exchange line access number and with a area code)

permanent config: Call forwarding for external numbers is enabled, disabled or switched over in the permanent configuration.

current conf.: Call forwarding for external numbers is enabled, disabled or switched over only in the current configuration.