Function Key for Phone Lock

Functions > Phone Lock > Function Key for Phone Lock

Function Key for Phone Lock

Press the key on the telephone in the idle state and enter the user PIN to enable the phone lock.

Press the key again and then enter the user PIN, sub-admin or admin PIN to disable the phone lock again.

In addition the status of the function is indicated by the corresponding LED.

LED signalling on the key:
Red	The phone lock is enabled.
Off	The phone lock is disabled.

Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.

Requirements for operating the function:

•

Configured user, subadmin or admin PIN

•

For enabling the function: Knowledge of the user PIN

•

For disabling the function: Knowledge of the user, subadmin or admin PIN

Proceed as follows by assigning the function key:

•

Using COMfortel Set by selecting Phone lock

•

Using the telephone by selecting phone lock

Note: For further information about the general procedures when assigning function keys, see Function Keys.

COMfortel 1600 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V10 02/2019