Basic Knowledge > Configuration Software COMfortel Set > Configuring Interface Used
Configuring Interface Used
Requirements:
•
Existing PC connection to a PC interface on the PBX or a connected system telephone
 
1.
Open the menu Options > Interface....
2.
In the Interface list field, select one of the following options:
IP network: Enable the existing connection via the Ethernet interface on the PBX for carrying out the transmission.
USB: Enable the existing connection via the USB interface on the PBX or a connected system telephone for carrying out the transmission. (No other action is required.)
Note: For an indirect PC connection to the system telephone to be configured, the selection IP network is significantly faster than via other selections.
 
3.
In the IP address entry field, enter the IP address of the PBX (only applies to the option IP network). Possible entries:
IP address with areas from 0 to 255 (example: 192.168.0.240)
4.
in the IP port (default: 7002) entry field, enter the configuration port for system telephones on the PBX (only applies to the option IP network). Possible entries:
1 to 65535
5.
Click OK.
COMfortel 1600 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V10 02/2019