Configuring a Call Macro

A call macro can contain numbers as well as certain control characters. This enables you, for example, to query an answering machine.

Proceed as follows:

•

Using COMfortel Set

•

Using the telephone

Using COMfortel Set to Configure a Call Macro

Open a contact for editing or create a new contact.

In the Kind list field, select the macro option.

Enter the call macro in the Phone number entry field. Possible entries:

	Up to 40 digits
	Digits and the characters * and #
	The following commands:
-	Waiting time/pause time of 1 second
=	Waiting time/pause time of 2 seconds
<	Waiting time/pause time of 4 seconds
W	Wait for a connection
H	Replace/pick up receiver

Using the Telephone to Configure a Call Macro

Open a contact for editing or create a new contact.

Tap on

(not applicable when configuring a new contact).

Tap on

Enter a call macro. Possible entries:

Up to 40 digits

Digits and the characters * and #

Commands

Tap on

to add a command.

Select one of the following options and confirm with OK.

pause: 1 second: Inserts a pause of one second.

pause: 2 seconds: Inserts a pause of two seconds.

pause: 4 seconds: Inserts a pause of four seconds.

wait for connect: Inserts a pause that lasts until the connection is established. (If no connection is possible, the macro ends.)

repl/lift hands: Ends the connection or initiates, it depending on the status.

Important: If you must prefix e.g. an exchange line access number when entering/selecting a phone number, depends on the exchange line request (automatic, direct exchange line telephone, internal telephone) that was configured in the PBX (see Advanced Information of the PBX).