Functions > Boss/Secretary Function > Secretary Key on Boss Telephone
Secretary Key on Boss Telephone
Note:
It is not possible to configure boss keys and secretary keys to exist simultaneously on the same telephone;  this means that a telephone cannot be both a boss telephone and a secretary telephone at the same time.
When operated on the PBXs COMpact 2206 USB and COMpact 4410 USB: A maximum of five secretary keys can be configured on a boss telephone.
When operated on the PBXs COMpact 3000 analogue/ISDN/VoIP, COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 4000, COMpact 5000/R, COMpact 5200/R, COMpact 5500R and COMmander 6000/R/RX: A maximum of one secretary key can be configured on a boss telephone. Multiple secretary telephones must be linked in a group.
 
Press the key while in the telephone's idle state to switch the boss/secretary function on or off.
During an incoming call, rerouted calls are shown on the display of the boss telephone. Press the secretary key to pick up this call.
In addition, the corresponding LED indicates the status of the function.
 
LED signalling on the secretary key:
Green
The boss/secretary function is enabled. The secretary telephone is currently not being used for a call. Press the key to switch the boss/secretary function on or off.
Red (blinking)
The boss/secretary function is enabled. A call has just been forwarded to the associated secretary. Press the key to initiate a pick-up.
Red
The boss/secretary function is enabled. The associated secretary is not available. In this case, a caller hears a busy signal unless call waiting is enabled on the secretary telephone. If the boss/secretary function is still enabled for additional telephones, the call is rerouted to one of them.
Off
The boss/secretary function is disabled. Press the key to enable the boss/secretary function.
 
Requirements for operating the function:
•
A suitably configured boss key on the secretary telephone
 
Proceed as follows by assigning the function key:
•
Using COMfortel Set by selecting Secretary key
•
Using the telephone by selecting secretary key
Note: For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
 
Configuration with COMfortel Set
 
Secretary – Telephone no 
Internal phone number for the secretary telephone.
 
 
Configuration with the Telephone
 
Telephone no
Internal phone number for the secretary telephone.
COMfortel 1400 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019