Functions > Targeted VoIP Access Point > Function Key for Targeted VoIP Access Point

Function Key for Targeted VoIP Access Point
Important: Only available for operation on the PBXs COMpact 3000 analogue/ISDN/VoIP, COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 4000, COMpact 5000/R, COMpact 5200/R, COMpact 5500R and COMmander 6000/R/RX.
Press the key to initiate a targeted VoIP access point. This allows you to immediately dial the external phone number.
Important: If you must prefix e.g. an exchange line access number when entering/selecting a phone number, depends on the exchange line request (automatic, direct exchange line telephone, internal telephone) that was configured in the PBX (see Advanced Information of the PBX).
In addition the status of the channels for the targeted VoIP access point is indicated by the corresponding LED.
Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.
Requirements for operating the function:
Proceed as follows by assigning the function key:
Note: For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
Configuration with COMfortel Set
Account numberTelephone no 
Account number of the VoIP account
Configuration with the Telephone
Telephone no
Selection of a VoIP account.

COMfortel 1400 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019