Functions > Group Functions > Display of the Group Status

Display of the Group Status
Important: Only available for operation on the PBXs COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 4000, COMpact 5000/R, COMpact 5200/R, COMpact 5500R and COMmander 6000/R/RX.
Press the key in the idle mode of the telephone to display the current group status of the subscribers (logged out, logged in as incoming and/or outgoing) on the LEDs of configured speed dialling keys for approx. ten seconds. For this purpose, the speed dialling keys must be assigned to the corresponding subscriber numbers. Press the key again during the ten seconds to cancel the display.
Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.
Requirements for operating the function:
Proceed as follows by assigning the function key:
Note: For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
Configuration with COMfortel Set
group log statusTelephone no 
Phone number of the group.
Configuration with the Telephone
Telephone no
Selection of the group by its name/its number.

COMfortel 1400 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019