Functions > Configuration Switchover > Function Key for Configuration Switchover

Function Key for Configuration Switchover
Press the key for general functions while the telephone is in the idle state to open the Configuration menu. After this, you can enable the configuration.
Press the key defined for configurations to enable the configuration that has been set up.
In addition the status of the function is indicated by the corresponding LED.
 
Note: When functions are defined on the second key level (optional, see Technical Data in the Instructions), LED signalling is not available.
 
Requirements for operating the function:
Authorisation in the PBX for Configuration switching
 
Proceed as follows by assigning the function key:
Note: For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
 
Configuration with COMfortel Set
 
configuration to be activated 
Selection of a configuration (depending on the PBX type).
 
Identification number   
Marks the identification number of a configuration (depending on the PBX type).
 
 
Configuration with the telephone
 
general: Press the key to open the switch configuration menu.
defined: Press the key to enable the set configuration.
 
Configuration
Selection of a configuration.

COMfortel 1400 - Firmware V2.2 - COMfortel Set V3.16 - Advanced Information V07 02/2019