Function Key for Macro

Press the key while the telephone is in the idle state to execute a macro. If the H command (hang-up/pick-up with the hook key) is located at the beginning of a macro, the macro saved in the system is executed immediately. If this is not the case, you need to first confirm the start of macro execution.

In addition and depending on the settings the status of the macro in question is indicated by the corresponding LED.

LED signalling on the key:
Depending on the purpose of the commands Lo, Lg, Lr and Ly.

Note: If there is a macro on both levels of a function key, LED control is also performed by the macro on the second level. This makes it possible, for instance, to use the macro to switch the LED on the one key level and to use the macro to switch LED off on the other key level. This allows the switching status of a simultaneously switched function to be read on the LED.

Proceed as follows by assigning the function key:

•

Using COMfortel Set by selecting Macro

•

Using the telephone by selecting macro

Note: For further information about the general procedures when assigning function keys, see Function Keys.

Additional settings for this function key are described in the following.

Configuration with COMfortel Set

Macro sign

Up to 100 characters for a max. of 10 keys, up to 40 characters for additional keys
The following commands:
Z [digit sequence]	Digit sequence selection including * and #
W [digits 1-5]	Waiting time/pause time of 1-5 seconds
K	Switchover to keypad
M	Switchover to DTMF
H	Hang-up/pickup with the hook key
C	Wait for a connection
Lo	The LED on the function key switches off
Lr	The LED on the function key switches on (red)
Ly	The LED on the function key switches on (yellow)
Lg	The LED on the function key switches on (green)

Note:

If you want to configure a programming function on the PBX as a macro, enter a pause between the password and programming code sequence.

Pauses cannot be entered at the beginning of a macro.

The maximum pause time is 5 seconds. This restriction does not apply for the C command (waiting for a connection).

Configuration with the Telephone

macro

Up to 100 characters for a max. of 10 keys, up to 40 characters for additional keys
The following commands:
Z [digit sequence]	Digit sequence selection including * and #
W [digits 1-5]	Waiting time/pause time of 1-5 seconds
K	Switchover to keypad
M	Switchover to DTMF
H	Hang-up/pickup with the hook key
C	Wait for a connection
Lo	The LED on the function key switches off
Lr	The LED on the function key switches on (red)
Ly	The LED on the function key switches on (yellow)
Lg	The LED on the function key switches on (green)

Note:

If you want to configure a programming function on the PBX as a macro, enter a pause between the password and programming code sequence.

Pauses cannot be entered at the beginning of a macro.

The maximum pause time is 5 seconds. This restriction does not apply for the C command (waiting for a connection).