Functions > InterCom Announcement/Hands-free calling > Function Key for InterCom Announcement
Function Key for InterCom Announcement
Press the key when the telephone is in its idle state to select the subscriber number or group number stored on the key and initiate the InterCom announcement. Depending on the action type configured, you need to hold the key during the announcement (as soon as you release the key again, the connection is terminated) or switch the key over by briefly pressing the key (the key is pressed once at the start and once at the end).
In addition, when InterCom destination is defined on the first key level, the status of the InterCom destination connection is indicated by the corresponding LED.
 
LED signalling on the key (when assigned to an internal subscriber number):
green
There is currently an active connection to the InterCom destination.
off
There is currently no active connection to the InterCom destination.
 
LED signalling on the key (when defined with an internal group number):
green
An active connection to all InterCom destinations is present.
green (blinking)
The InterCom call is sent to the PBX.
yellow
There is currently an active connection to at least one InterCom destination.
red
No InterCom destination is accessible.
 
Requirements for using the function:
•
Telephone is a system telephone on the PBX or InterCom announcement is performed on the PBX for which the sequence ##011 has been entered under Ajustes > Proveedores y centralitas > Name of Provider/PBX > Números especiales > Keypad sequence for InterCom hands-free calling
•
InterCom permission is present at the InterCom destination
 
Proceed as follows by assigning the function key:
•
Using the Configuration Manager by selecting Aviso InterCom
•
Using the telephone by selecting Aviso InterCom
Notes:
The function can only be set up on a programmable function key that has an LED (not on a touch function key).
For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
Operación 
Retener llamada:The key must be held down during the announcement
cambiar: A short press of the key starts the announcement. Another short press of the key ends the announcement
 
Cuenta 
Select the account for the PBX
 
Destino de InterCom 
Enter the internal number
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V03 12/2020