Settings > Display > Settings Configuration Manager Display
Settings Configuration Manager Display
Proceed as follows:
•
Using the Configuration Manager (page Paramètres > Appareil > Affichage)
Brightness
  Éteindre l’écran
 Display will be switched off in power save mode.
 Display will be dimmed in power save modede.
  Luminosité automatique (COMfortel 3600 IP)
 The automatic brightness is disabled. A regulator for setting the display brightness manually pops up.
 Luminosité (COMfortel 1400 IP and 2600 IP)
Move the regulator to the left or right to reduce or raise the display brightness.
LED settings
  DEL Messages
Clignote et reste allumée en continu Indicates new entries, or entries that have already been viewed.
Clignote uniquement Indicates new entries.
désactiver LED is always switched off.
  Signalisation de messageries de télécopie
If you find the LED signals of the fax boxes disruptive or annoying, they can be switched off separately.
 New fax entries will be signalled.
  DEL Écran (only COMfortel 1400 IP and 3600 IP)
The different telephone states can be set (e. g. missed calls, new messages, etc.). Configure which telephone state is to be signalled or if the signalling shall be switched off completely.
Afficher les appels et les conversations Indicates the status of the call.
Afficher les appels, les conversations et le mode micro-casque Indicates the status of the call and the headset activation (only COMfortel 3600 IP).
Show alerting, calls and new messages: Indicates the status of the call and new messages.
désactiver LED is always switched off.
 
  Statut d’enregistrement de l’abonné VoIP
 If not registered on the PBX, the speed dialling key signals unregistered VoIP subscribers in yellow.
 No signalling of the registration status.
Idle state and Power Saving Mode
Veille 
The selected time indicates after how many seconds/minutes without action the telephone switches into the idle state. Then, the display no longer reacts on touch. If Aucune automatique is selected, the telephone will not automatically be set into the idle state.
 
Configuration-dependent idle state
ID configuration 
The telephone changes into the idle state if the PBX switches over into a specific configuration (e. g. night configuration).
Requirements:
•
Configured configuration in the PBX (see Advanced Information of the PBX)
•
Enabled Configuration switchover check box in the PBX
Enter the configuration ID of the configuration.
Note: To switch off the configuration-dependent idle state, delete the configuration ID in the ID configuration entry filed and click OK.
 
 
Comportement du mode d’économie d’énergie 
The selected time indicates after how many minutes in the idle state the power save mode will be switched on. The background lighting will then be dimmed or switched off completely and the LEDs are inactive (exception: message LED for missed calls).
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V04 03/2024