Function Key for Targeted Exchange Line Access

Functions > Targeted Exchange Line Access (System Telephone) > Function Key for Targeted Exchange Line Access

Function Key for Targeted Exchange Line Access

Press the key to initiate targeted exchange line access. You can then immediately dial the external number (without exchange line access number).

In addition, when functions are defined on the first key level, the status of the account is indicated by the corresponding LED.


LED signalling on the key:
red	All the account's call channels are occupied (call not possible).
yellow	At least one of the account's call channels is available. Press the key to use the call channel that is still available.
off	All the account's call channels are available. Press the key to occupy one of the available call channels.

Requirements for using the function:

•

Telephone is system telephone on the PBX

Proceed as follows by assigning the function key:

•

Using the Configuration Manager by selecting Centralino

•

Using the telephone by selecting Centralino

The function can only be set up on a programmable function key that has an LED (not on a touch function key).

For further information about the general procedures when assigning function keys, see Function Keys.

Additional settings for this function key are described in the following.

Select system telephony account

Enter the external number that you want to transfer during targeted exchange line access (without an exchange line access number and without a prefix)

COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V03 12/2020