Functions > Group Function (System Telephone) > Function Key for Displaying the Group State
Function Key for Displaying the Group State
Press the key while the telephone is in the idle state to display the current group state of the subscribers (logged out, logged in as incoming and/or outgoing) on the LEDs of configured speed dialling keys for approx. 10 seconds. For this purpose the speed dialling keys must be assigned to the corresponding subscriber numbers. Press the key again within 10 seconds to cancel the display.
 
LED signalling on the key:
green (blinking)
The group state is being queried.
off
The group state is not being queried.
 
LED signalling on the speed dialling keys assigned to subscriber numbers:
red
The telephone is logged out of the group.
green
The telephone is logged in to the group for incoming and outgoing calls.
yellow
The telephone is logged in to the group for incoming calls.
yellow (blinking)
The telephone is logged into the group for outgoing calls.
 
Requirements for using the function:
•
Telephone is system telephone on the PBX
•
Speed dialling keys assigned to the corresponding subscriber numbers.
 
Proceed as follows by assigning the function key:
•
Using the Configuration Manager by selecting Stato gruppo
•
Using the telephone by selecting Stato gruppo
Notes:
For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
Account 
Select system telephony account.
 
Gruppi 
Enter a group number
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V03 12/2020