Settings > Display > Settings Configuration Manager Display
Settings Configuration Manager Display
Proceed as follows:
•
Using the Configuration Manager (page Impostazioni > Dispositivo > Schermo)
Brightness
  Spegni schermo
 Display will be switched off in power save mode.
 Display will be dimmed in power save modede.
  Luminosità automatica (COMfortel 3600 IP)
 The automatic brightness is disabled. A regulator for setting the display brightness manually pops up.
 Luminosità (COMfortel 1400 IP and 2600 IP)
Move the regulator to the left or right to reduce or raise the display brightness.
LED settings
  LED messaggi
Lampeggiamento e luce fissa Indicates new entries, or entries that have already been viewed.
Solo lampeggiamento Indicates new entries.
disattiva LED is always switched off.
  Segnalazione caselle fax
If you find the LED signals of the fax boxes disruptive or annoying, they can be switched off separately.
 New fax entries will be signalled.
  LED schermo (only COMfortel 1400 IP and 3600 IP)
The different telephone states can be set (e. g. missed calls, new messages, etc.). Configure which telephone state is to be signalled or if the signalling shall be switched off completely.
Mostra chiamate e conversazioni Indicates the status of the call.
Mostra chiamate, conversazioni e funzionamento ricevitore Indicates the status of the call and the headset activation (only COMfortel 3600 IP).
Show alerting, calls and new messages: Indicates the status of the call and new messages.
disattiva LED is always switched off.
 
  Stato di registrazione dei partecipanti VoIP
 If not registered on the PBX, the speed dialling key signals unregistered VoIP subscribers in yellow.
 No signalling of the registration status.
Idle state and Power Saving Mode
Stand-by 
The selected time indicates after how many seconds/minutes without action the telephone switches into the idle state. Then, the display no longer reacts on touch. If Nessun automatismo is selected, the telephone will not automatically be set into the idle state.
 
Configuration-dependent idle state
ID configurazione 
The telephone changes into the idle state if the PBX switches over into a specific configuration (e. g. night configuration).
Requirements:
•
Configured configuration in the PBX (see Advanced Information of the PBX)
•
Enabled Configuration switchover check box in the PBX
Enter the configuration ID of the configuration.
Note: To switch off the configuration-dependent idle state, delete the configuration ID in the ID configurazione entry filed and click OK.
 
 
Comportamento della modalità risparmio energetico 
The selected time indicates after how many minutes in the idle state the power save mode will be switched on. The background lighting will then be dimmed or switched off completely and the LEDs are inactive (exception: message LED for missed calls).
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V04 03/2024