Functions > Configuration Switchover (System Telephone) > Function Key for Configuration Switchover
Function Key for Configuration Switchover
Press the key to enable the configuration that has been set up.
Note: For switching the automatic configuration switchover on/off, assign a function key for switching the system relay with operation mode automatic configuration switchover and the Identification number 900 (optional, see Advanced Information of the PBX). For further information about the procedure, see chapter Functions > Relays (System Telephone) > Function Key for Switching Relays.
 
In addition, when functions are assigned on the first key level, the status of the function is indicated by the corresponding LED.
 
LED signalling on the key:
green
The configuration saved in the key is enabled.
off
The configuration saved in the key is disabled.
 
Requirements for using the function:
•
Telephone is system telephone on the PBX
•
Configuration switchover permission granted in the PBX
 
Proceed as follows by assigning the function key:
•
Using the Configuration Manager by selecting Configurazione
•
Using the telephone by selecting Configurazione
Notes:
For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
Account 
Select the system telephony account.
 
Configurazione da attivare 
Configuration manager: select the configuration
Telephone: Enter identification number in the entry field
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V04 03/2024