Zurück


Settings > Display > Settings Configuration Manager Display
Settings Configuration Manager Display
Proceed as follows:
•
Using the Configuration Manager (page Ustawienia > Urządzenie > Ekran)
Brightness
  Ekran wyłączony
 Display will be switched off in power save mode.
 Display will be dimmed in power save modede.
  Automatyczna regulacja jasności (COMfortel 3600 IP)
 The automatic brightness is disabled. A regulator for setting the display brightness manually pops up.
 Jasność (COMfortel 1400 IP and 2600 IP)
Move the regulator to the left or right to reduce or raise the display brightness.
LED settings
  Dioda LED wiadomości
Tryb migania i ciągły Indicates new entries, or entries that have already been viewed.
Tryb migania Indicates new entries.
wyłączanie LED is always switched off.
  Sygnalizacja skrzynek faksów
If you find the LED signals of the fax boxes disruptive or annoying, they can be switched off separately.
 New fax entries will be signalled.
  Dioda LED ekranu (only COMfortel 1400 IP and 3600 IP)
The different telephone states can be set (e. g. missed calls, new messages, etc.). Configure which telephone state is to be signalled or if the signalling shall be switched off completely.
Wyświetlaj powiadomienia o połączeniach i rozmowach Indicates the status of the call.
Wyświetlaj powiadomienia o połączeniach, rozmowach i trybie zestawu słuchawkowego Indicates the status of the call and the headset activation (only COMfortel 3600 IP).
Show alerting, calls and new messages: Indicates the status of the call and new messages.
wyłączanie LED is always switched off.
 
  Stan rejestracji abonenta VoIP
 If not registered on the PBX, the speed dialling key signals unregistered VoIP subscribers in yellow.
 No signalling of the registration status.
Idle state and Power Saving Mode
Stan uśpienia 
The selected time indicates after how many seconds/minutes without action the telephone switches into the idle state. Then, the display no longer reacts on touch. If Brak blokady automatycznej is selected, the telephone will not automatically be set into the idle state.
 
Configuration-dependent idle state
Identyfikator konfiguracji 
The telephone changes into the idle state if the PBX switches over into a specific configuration (e. g. night configuration).
Requirements:
•
Configured configuration in the PBX (see Advanced Information of the PBX)
•
Enabled Configuration switchover check box in the PBX
Enter the configuration ID of the configuration.
Note: To switch off the configuration-dependent idle state, delete the configuration ID in the Identyfikator konfiguracji entry filed and click OK.
 
 
Zachowanie trybu oszczędzania energii 
The selected time indicates after how many minutes in the idle state the power save mode will be switched on. The background lighting will then be dimmed or switched off completely and the LEDs are inactive (exception: message LED for missed calls).
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V05 12/2020