Function Key for InterCom Hands-Free Calling

Functions > InterCom Announcement/Hands-free calling > Function Key for InterCom Hands-Free Calling

Function Key for InterCom Hands-Free Calling

Press the key when the telephone is in its idle state to select the phone number stored on the key and initiate the InterCom hands-free call. Depending on the action type configured, you need to hold the key during hands-free operation (as soon as you release the key again, the connection is terminated) or switch the key over by briefly pressing the key (the key is pressed once at the start and once at the end).

In addition, when InterCom destination is defined on the first key level, the status of the InterCom destination connection is indicated by the corresponding LED.


LED signalling on the key:
green	There is currently an active connection to the InterCom destination.
green (blinking)	The InterCom call is sent to the PBX.
red	InterCom destination not accessible.
off	There is currently no active connection to the InterCom destination.

Requirements for using the function:

•

Telephone is a system telephone on the PBX or InterCom announcement is performed on the PBX for which the sequence ##012 has been entered under Ustawienia > Usługodawcy i centrale telefoniczne > Name of Provider/PBX > Połączenia ze specjalnymi taryfami > Keypad sequence for InterCom hands-free calling.

•

InterCom permission is present at the InterCom destination

Proceed as follows by assigning the function key:

•

Using the Configuration Manager by selecting Tryb głośnomówiący Interkom

•

Using the telephone by selecting Tryb głośnomówiący Interkom

The function can only be set up on a programmable function key that has an LED (not on a touch function key).

For further information about the general procedures when assigning function keys, see Function Keys.

Additional settings for this function key are described in the following.

Zawieś połączenie:The key must be held down during the announcement

przełącz: A short press of the key starts the announcement. Another short press of the key ends the announcement

Select the account for the PBX

Odbiorca połączenia interkomowego

Enter the internal number

COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V05 12/2020