Functions > InterCom Announcement/Hands-free calling > Function Key for InterCom Hands-Free Calling
Function Key for InterCom Hands-Free Calling
Press the key when the telephone is in its idle state to select the phone number stored on the key and initiate the InterCom hands-free call. Depending on the action type configured, you need to hold the key during hands-free operation (as soon as you release the key again, the connection is terminated) or switch the key over by briefly pressing the key (the key is pressed once at the start and once at the end).
In addition, when InterCom destination is defined on the first key level, the status of the InterCom destination connection is indicated by the corresponding LED.
 
LED signalling on the key:
green
There is currently an active connection to the InterCom destination.
green (blinking)
The InterCom call is sent to the PBX.
red
InterCom destination not accessible.
off
There is currently no active connection to the InterCom destination.
 
Requirements for using the function:
•
Telephone is a system telephone on the PBX or InterCom announcement is performed on the PBX for which the sequence ##012 has been entered under Settings > Providers & PBXs > Name of Provider/PBX > Special numbers > Keypad sequence for InterCom hands-free calling.
•
InterCom permission is present at the InterCom destination
 
 
Proceed as follows by assigning the function key:
•
Using the Configuration Manager by selecting InterCom Hands-free calling
•
Using the telephone by selecting InterCom Hands-free calling
Notes:
The function can only be set up on a programmable function key that has an LED (not on a touch function key).
For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
Operation 
Hold:The key must be held down during the announcement
toggle: A short press of the key starts the announcement. Another short press of the key ends the announcement
 
Account 
Select the account for the PBX
 
InterCom destination 
Enter the internal number
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V08 12/2020