Functions > Call Forwarding > Function Key for Call Forwarding for Subscribers in the PBX
Function Key for Call Forwarding for Subscribers in the PBX
Press the key to which Call fwd. (scr. in PBX) has been assigned to switch call forwarding for subscribers for the configured destination in the PBX on or off, or toggle it.
The key assigned to switch off all call forwarding for subscribers (Call fwd. (scr.), deactivate all) switches off call forwarding for subscribers.
In addition, when functions are assigned on the first key level, the status of the function is indicated by the corresponding LED.
 
LED signalling on the key (not applicable if assigned with "deactivate all"):
red
Subscriber call forwarding is enabled for the configured destination.
yellow
Subscriber call forwarding is enabled for a different destination.
off
Subscriber call forwarding is disabled.
 
Requirements for using the function:
•
Telephone is system telephone on the PBX
 
Proceed as follows by assigning the function key:
•
Using the Configuration Manager by selecting Call fwd. (scr. in PBX)
•
Using the telephone by selecting Call fwd. (scr. in PBX)
Notes:
For further information about the general procedures when assigning function keys, see Function Keys.
Additional settings for this function key are described in the following.
 
 
Forwarding type 
unconditional: "call forwarding (unconditional)" function for the subscriber
on busy: "call forwarding (on busy)" function for the subscriber
not responding: "call forwarding (if not responding)" function for the subscriber
 
Forwarding destination 
Enter destination number
Important:
If a destination number key is adopted from the telephone book, it must be changed, if necessary, by hand as the adopted phone number could contain invalid special characters (permitted are the special characters # and *).
Internal destination: The internal phone number without ** must be entered.
External destination: The exchange line access number must always be entered if the automatic exchange line request is disabled. If the automatic exchgange line request is enabled, the phone number must always be entered without exchange line access number.
 
COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.8 - Advanced Information V08 12/2020