Analogue Settings
Proceed as follows:
•Separately for subscribers
•Using the Configuration Manager
•Subscriber-related (page Abonnés (Abo) > Propriétés)
Abonné
Select the subscriber you want to display/configure.
•Function-related (page Abonnés (Abo) > Synthèse des fonctions)
Configurer
Opens the configuration of the single function for all subscribers.
Important: The settings done are only valid on the condition that they are not overridden by a profile. The simultaneous display takes place only on page Abonnés (Abo) > Propriétés under Surmodulé par le biais du profil dans la configuration.
Note: [Name configuration] ...: In the displayed configuration, the function is overridden by the displayed setting. Configuration using the Configuration Manager (page Abonnés (Abo) > Profils > ...)Note: faculté libre: The function is currently not overridden by a profile.Note: (non commandé par le profil): The function can not be overridden by a profile.Requirements:
•Subscriber is an analogue end device
Infos CLIP
Requirements:
•Subscriber is a CLIP-capable analogue phone
The phone number information (if transmitted) is displayed on the display of the phone.
Infos CLIP étendues
Requirements:
•Subscriber is a CLIP-capable analogue phone
In the caller list of the phone date and time of missed calls are recorded. The name can be displayed instead of or in addition to the phone number.
Note: For some end devices, extended CLIP information can cause problems and should therefore be disabled.Charge pulse
AOCD - enabled
Switches on the conversion of charge information sent during the call into charge pulses. The subscriber can evaluate the charge information sent to them by the network provider transferred to display the charges they incur.
AOCE - aussi vite que possible
Switches on the conversion of charge information send at the end of the call into charge pulses. The subscriber can evaluate the charge information sent to them by the network provider transferred to display the charges they incur.
Aucune
Switches off the conversion of the transferred charge information into charge pulses.
Note: If the network provider sends charge information during and at the end of the call (AOCD) and you have specified this for the subscriber, it may happen that not all the charges can be sent before the call is ended. The remaining information is then transferred at the beginning of the next call.Note: The charge pulse option should be switched off (Aucune) for faxes and modems to prevent transfer problems.Note: You will hear a slight crackling on the line when the charge pulse is switched on.Durée du flashing (décrocher-raccrocher)
Hook flash timing enables the PBX to detect a flash signal from the subscriber in question.
For this to work, the hook flash timing must correspond with the time that is configured for the flash signal on the analogue end device (see the phone manual).
Note: DTMF phones that execute various functions using the T-Net function key/menu use a flash of 300 ms to do this. In order to also use these functions on the PBX, the same time as the hook flash timing must be configured on the PBX. Usually, there is an additional flash button available on this phone that must also be configured with this value (see the phone manual).Note: Note that the PBX does not detect a receiver being hanged up until after hook flash timing is finished.Sonnerie pour les appels internes
The ringtone specifies which sequence of sounds is used to signal internal calls to internal subscribers on the PBX.