VMF Slot X/XVoIP Slot X
Proceed as follows:
•Using the Configuration Manager (page Administration > IP Configuration)
Configure the Ethernet configuration on the VMF or the VoIP module.
Note: If you do not want to assign a permanent IPv4 address to the module, clear the check box Receive the IP address automatically (DHCP client).Requirements:
•Inserted COMmander VMF module or COMmander VMF-R module or inserted COMmander 8/16VoIP module or COMmander 8/16VoIP-R module
Receive the IP address automatically (DHCP client)
The PBX automatically receives its IP address from the DNS server.
Assigning IP address manually
Requirements:
•Disabled DHCP client
IP address
IPv4 address in the range 0-255 (example: 192.168.0.240).
Apply immediately
The IPv4 address is immediately applied and the PBX is routed to the new IPv4 address. Renewed registration required.
Apply at restart
The IPv4 address is not applied until the next time the PBX is restarted.
Subnet mask
IPv4 address of the subnet mask in the range 0-255 (example: 255.255.255.0).
Gateway
IPv4 address of the gateway in the range 0-255 (example: 192.168.0.2).
IPv6 Configuration
Opens the IPv6 configuration.
IPv6 mode
If IPv6 is switched on, an IP address complying with version 6 of the Internet protocol can be assigned to the PBX. Thanks to the greater length of IPv6 addresses (eight blocks with four digits each, example: 3001:00FF:ABC0:0EAC:0001:0000:0000:000F), IPv6 offers a greater number of available IP addresses than version 4 of the Internet protocol (IPv4).
disabled
Switches the use of IPv6 addresses off.
SLAAC
Automatically assigns an IPv6 address to the PBX.
static
Assigns a user-defined IPv6 address to the PBX.
Note: If IPv6 has been disabled for the PBX, IPv6 can also not be enabled for any modules. If, in the reverse, IPv6 has been enabled for the PBX, it is also enabled automatically for all modules and cannot be disabled.IPv6 settings
Requirements:
•IPv6 status IPv6 static selected
IPv6 address
Enter the IPv6 address of the PBX.
Prefix length
Enter the prefix length in the range 1 to 128. The prefix specifies to which subnet the IPv6 address belongs.
IPv6 Gateway
Enter the IPv6 gateway. Possible entries: Digits, characters and :.