2TSM Module

Buch1 > Using the Configuration Manager > Devices > Relays (Actuators) > Settings of the Relays (Actuators) > 2TSM Module

2TSM Module

Proceed as follows:

•Using the Configuration Manager (page Devices > Relays (actuators) > Configure)

CONFIGURATION OF THE RELAY

Select the relay.

Switching duration

Specifies after how many seconds the PBX will switch off the relay. Possible entries: 0 bis 6000 (0 only for manual relays).

Note: The switching duration is used for relays with the operating modes Light, Door opener, Alarm, PC relay and Manual relay.

Note: To enable the PBX to switch off the relay after the specified switching duration, off control must be supported by the relay and be switched on (for some relays, e. g. the a/b Switching Modules, switching off cannot be controlled). Alternatively, the hold time of the relay can be used.