Switch Input+Relay
Proceed as follows:
Separately for switch inputs
Using the Configuration Manager (Périphériques > Alarmes > Entrée > )
Requirements:
Created switch input
Configuration de l’entrée
Select the switch input to be configured.
Niveau
Requirements:
Created switch input for a COMmander 2TSM(R) module
The level must be configured depending on the signal applied.
High level
A voltage of 5-15 V AC/DC was applied.
Low level
GND was applied.
Séquence DTMF
Requirements:
Created switch input for an analogue device
Specifies which DTMF sequence the PBX detects, for example,as the actuation of a door bell button to then trigger an alarm or a door call. For information about which DTMF sequences the connected device sends, see the manual of the device in question.
*Note: The DTMF sequence usually is the phone number assigned to the door bell button within the door terminal.
Invite SIP
Requirements:
Created switch input for a VoIP device
Specifies which SIP invite the PBX detects, for example,as the actuation of a door bell button to then trigger an alarm or a door call. For information about which SIP invite the connected device sends, see the manual of the device in question.
*Note: The SIP invite usually is the phone number assigned to the door bell button within the door terminal.