Settings all Subscribers
Proceed as follows:
•Using the Configuration Manager (Subscriber (scr.) > All subscribers)
Max. duration of switched/forwarded calls: external with external (1..600 min.)
Specifies after how many minutes the PBX end the transferred or forwarded call (external with external), if two call channels of the PBX were used for forwarding.
Frequency of the charge meter pulse
The charge pulse frequency is adjustable, if necessary (depending on the country settings of the PBX).
Note: 16 kHz is the standard value in Germany.Ringer frequency
Specifies the ringer voltage frequency the PBX uses to signalise calls to internal analogue subscribers.
ISDN scr may move with phone/change ports
The ISDN devices may be connected to any internal S0/UP0 port. The PBX recognises the subscriber and moves him to another port.
Note: When switched off, an ISDN device may be plugged into another RJ socket of the internal S0/UP0 port, but it has to be the same internal bus.Delay time for baby / senior call (1..20 sec.)
Specifies after how many seconds the destination number is dialled automatically after picking up the receiver
Differently configurable functions for private and business calls
Two different configurations can be created for each of the functions listed below – one for private calls and one for business calls.
Note: When switched off, only one configuration can be created for the functions listed below. This applies to private calls as well as to business calls.Note: If differently configurable functions for private and business calls are disabled, the PBX takes over the configuration for business calls as joint configuration.Note: If differently configurable functions for private and business calls are enabled again, the PBX takes over the settings changed since the last disabling only for business calls. For this reason, you will need to check the configurations for private calls.Subscribers may create own passwords
Subscribers may generate additional Configuration Manager or API passwords as well as delete existing passwords. If under Devices > Action URLs, Subscribers may generate own passwords for accessing Action URLs is activated, then the subscriber may also generate or delete passwords for Action URLs.