Uploading the Configuration Automatically
Proceed as follows:
• Using the PBX
Requirements:
• PBX set to factory settings
• Configuration file named auconfig.cfg saved on a USB memory stick
Warning: Touching voltage-carrying conductors or phone connections can cause life-threatening electric shocks.• For some installation and maintenance work, it is necessary to open the PBX while it is in operation (qualified electrician only). Make sure that the PBX is never left unattended while working with an open casing. Close the casing after completing this work.
• Only a qualified electrician may perform installation work within an open casing or service work using the buttons inside the casing. If necessary, commission a specialised dealer to perform this work.
Warning: Power surges, which can occur during electrical storms, can cause life-threatening electric shocks and damage or destroy the PBX.• Do not open the PBX during an electrical storm.
1.Turn the PBX off.
2.Insert the USB memory stick into the USB port (USB host) on the COMpact 4000 interface board.
3.Turn the PBX on.
The configuration data saved on the USB memory stick is automatically saved in the PBX. Finally, the PBX restarts.
If the Power LED lights up in green again, the restart is complete and the PBX is ready for operation.
Note: If the Power LED remains continuously lit in red, an error has occurred. Please contact your specialised dealer or the manufacturer directly. Note: Any network settings saved in the configuration file will be taken over during automatic uploading. If the network settings were not saved in the configuration file, the factory network settings will be retained.