Settings Announcement Output
Proceed as follows:
Separately for announcement outputs
Using the Configuration Manager (page Devices > Announcement outputs > Configure)
Requirements:
Created announcement output
CONFIGURATION OF THE ANNOUNCEMENT OUTPUT
Select the announcement output you want to configure.
Enable connection
Finish connection
Specifies which DTMF sequences the PBX uses to control the analogue announcement outputs to enable or terminate the connection. For information about which DTMF sequences the connected device requires, see the manual of the device in question.
* Note: You can use the comma ',' character as a pause of half a second.
Dead time
Specifies how many milliseconds the PBX will wait before it sends DTMF sequences to the announcement output again. For information about how much time the connected device requires to be ready for reception again after receiving DTMF sequences, see the manual of the device in question.