Management Announcement Output

Buch1 > Using the Configuration Manager > Devices > Announcement Outputs > Management Announcement Output

Proceed as follows:

• Using the Configuration Manager (page Devices > Announcement outputs)

Phone number

This is an internal number. You can select any of the numbers in the internal supply of phone numbers. This number can be called directly by an internal subscriber. (Entry on page Devices > Device wizard)

Note: A number cannot be allocated twice.

Note: Using numbers with few digits (two- or three-digit numbers) inevitably restricts the possible supply of numbers that require more digits. For example, if the phone number 12 is assigned, the phone numbers 120 to 129 and 1200 to 1299 are no longer available.

Note: The default exchange line access number on the PBX is 0 in the factory settings. However, this can be changed. Note that changing the exchange line access number restricts the phone numbering plan.

Name

Freely selectable name. This name is used to identify the announcement output within the PBX and the connected system phones. The name can also be transferred to the VoIP end devices via LDAP server.

Module | Port

Module and port to which the device that can be used as announcement output (e. g. an a/b-Audiobox at a loudspeaker system) is connected.

Configure

Opens the configuration of the announcement output.

Relay

Requirements:

• Relay/actuator (optional, see Technical Data in the Instructions)

A relay with the operating mode Speaking, which is enabled during the loudspeaker announcement, is assigned to the alarm. This relay can be used to switch over the loudspeaker area of the loudspeaker system, for example, or to switch on an additional lamp which draws attention to the announcement.

If suitable relays have already been configured on the page Devices > Relays (Actuators), a list field will appear now. Select one of the existing relays and click

If you do not want to use any of the existing relays, select New relays in the list field (

cancels the operation). Enter a freely selectable name for the relay and click Ok.

Note: Alternatively, you can also create and assign relays on the page Devices > Relays (Actuators).

Note: For a detailed description of the operating modes, refer to .

Link to the page Devices > Relays (actuators)

Deletes the relay or opens the configuration of the relay.