Buch1 > Appendix Matériel > Status Displays on the LEDs
Status Displays on the LEDs
Status LED:
User prompt:
Flashes red (50/50 ms)
Pressing the Software default button is detected.
Flashes red (0,5/0,5 s)
The Software default button was pressed long enough.
Flashes orange (50/50 ms)
Pressing the Software altern. button is detected.
Flashes orange (0,5/0,5 s)
The Software altern. button was pressed long enough.


Status LED:
Power LED:
PBX status (after restart):
Lit in red
Lit in red
The boot partition is being tested.
Lit in orange
Lit in red
The kernel is being loaded from the partition.
Lit in green
Lit in red
The kernel is being initialised.
Lit in green
Lit in orange
The kernel modules are being loaded.
Lit in green
Flashes orange
The data base is being initialised/converted.
Lit in green
Lit in green
The PBX is ready for operation.


Status LED:
Power LED:
PBX status (in the case of an error):
Flashes red (1/1 s)
Lit in red
No valid boot partition was found. System is paused.
Flashes orange (1/1 s)
Lit in red
In both boot partitions no constant kernel data were found. System is paused.
*Note: If the Power LED remains constantly lit in red even after a restart, an error has occured. Please contact your dealer or the manufacturer directly.


Status LED:
Power LED:
PBX status (during powering down):
Lit in green
Flashes green
The delayed powering down has been enabled and the PBX waits for the termination of the last call.
Lit in green
Lit in red
The PBX is powered down completely.


LAN LED:
Status of the Ethernet Interface:
Off
No Ethernet connection to a computer/network exists.
Lit in green
An Ethernet connection to a computer/network exists (link).
Flashes green
An Ethernet connection to a computer/network exists (link) and packets are being transmitted.