Configuration Ethernet
Proceed as follows:
•Using the Configuration Manager (Administration > Configuration IP)
Disposer automatiquement de l’adresse IP (client DHCP)
Note: In the factory settings, DHCP is enabled.The PBX receives its IP address automatically from the DHCP server.
Assigning IP address manually
Requirements:
•Disabled DHCP client
Adresse IP
IPv4 address in the range 0-255 (example: 192.168.0.240).
Reprendre immédiatement
The IPv4 address is immediately applied and the PBX is routed to the new IPv4 address. Renewed registration required.
Reprendre en cas de redémarrage
The IPv4 address is not applied until the next time the PBX is restarted.
Masque de sous-réseau
IPv4 address of the subnet mask in the range 0-255 (example: 255.255.255.0).
Passerelle
IPv4 address of the gateway in the range 0-255 (example: 192.168.0.2).
Adresse IP fixe issue du domaine d’adresse APIPA
The PBX can be reached via the IP address 169.254.1.240, if
•it is directly connected to an individual computer which automatically receives its IP address.
•it is connected to a router that automatically assigns IP addresses.
Configuration IPv6
Opens the IPv6 configuration.
Mode IPv6
If IPv6 is switched on, an IP address complying with version 6 of the Internet protocol can be assigned to the PBX. Thanks to the greater length of IPv6 addresses (eight blocks with four digits each, example: 3001:00FF:ABC0:0EAC:0001:0000:0000:000F), IPv6 offers a greater number of available IP addresses than version 4 of the Internet protocol (IPv4).
Déconnecté
Switches the use of IPv6 addresses off.
SLAAC
Automatically assigns an IPv6 address to the PBX.
statique
Assigns a user-defined IPv6 address to the PBX.
IPv6 settings
Requirements:
•IPv6 status IPv6 static selected
Adresse IPv6
Enter the IPv6 address of the PBX.
Longueur de préfixe
Enter the prefix length in the range 1 to 128. The prefix specifies to which subnet the IPv6 address belongs.
Passerelle IPv6
Enter the IPv6 gateway. Possible entries: Digits, characters and :.