Status Displays on the LEDs
Status LED: | User prompt: |
|---|---|
Flashes red (50/50 ms) | Pressing the Software default button is detected. |
Flashes red (0,5/0,5 s) | The Software default button was pressed long enough. |
Flashes orange (50/50 ms) | Pressing the Software altern. button is detected. |
Flashes orange (0,5/0,5 s) | The Software altern. button was pressed long enough. |
Status LED: | Power LED: | PBX status (after restart): |
|---|---|---|
Lit in red | Lit in red | The boot partition is being tested. |
Lit in orange | Lit in red | The kernel is being loaded from the partition. |
Lit in green | Lit in red | The kernel is being initialised. |
Lit in green | Lit in orange | The kernel modules are being loaded. |
Lit in green | Flashes orange | The data base is being initialised/converted. |
Lit in green | Lit in green | The PBX is ready for operation. |
Status LED: | Power LED: | PBX status (in the case of an error): |
|---|---|---|
Flashes red (1/1 s) | Lit in red | No valid boot partition was found. System is paused. |
Flashes orange (1/1 s) | Lit in red | In both boot partitions no constant kernel data were found. System is paused. |
Note: If the Power LED remains constantly lit in red even after a restart, an error has occured. Please contact your dealer or the manufacturer directly.Status LED: | Power LED: | PBX status (during powering down): |
|---|---|---|
Lit in green | Flashes green | The delayed powering down has been enabled and the PBX waits for the termination of the last call. |
Lit in green | Lit in red | The PBX is powered down completely. |
LAN LED: | Status of the Ethernet Interface: |
|---|---|
Off | No Ethernet connection to a computer/network exists. |
Lit in green | An Ethernet connection to a computer/network exists (link). |
Flashes green | An Ethernet connection to a computer/network exists (link) and packets are being transmitted. |