Configurig IP Switch Relays
Proceed as follows:
•Using the Configuration Manager (Devices > Device wizard > Configure)
An existing IP switch relay can be connected to the PBX so that various functions controled by the PBX (see ) can be carried out. This IP switch relay must be created in the configuration of the PBX.
The IP switch relay and the relays available for it can be created with the device wizard. To control the relays, the PBX needs to know the IP address, port, user name (optional) and password of the connected device (see manual and settings of the device in question).
Various IP switch relays supported by the PBX are available as device templates. They already include several default values for operation of the IP switch relays in their factory settings.
If no of the device templates on offer matches your installation, you can select a user-defined device template.
In addition, you can select a simplified device template (IPBox Simple) which will make it easier for you to create an IP switch relay with the operating mode Manual relay.
IP configuration
IP address
Enter the IP address required by the connected device. Possible entries: IP address with a range of 0 to 255 (example: 192.168.0.240).
Port
Enter the port required by the connected device. Possible entries: 1 to 65535.
Note: Normally, the default port is port 80.User name
Enter the user name required by the connected device.
Password
Enter the password required by the connected device.
Relay X, Name
Enter the names of the relays.