Buch1 > Using the Configuration Manager > Functions > LAN TAPI > Settings for LAN TAPI > Settings
Settings
Proceed as follows:
•Using the Configuration Manager (Functions > LAN TAPI)
IP address or URL of the TSP client
If a TSP client is successfully registered for the first time, the IP address or URL of the device on which the TSP client is installed is entered automatically.
Network port of the TAPI server (1024-65535)
Port on the PBX which is used for communications with the TAPI server.
*Note: The new configuration will only become effective after the PBX or the TAPI server has been restarted.
Password for the network connection of the TAPI server
Freely selectable password that consists of 8 to 32 characters containing digits, letters (upper and lower case, but no German umlauts and ß) and special characters - _ . ! ~ * ' ( ) & = + $ ,. The password is used for communications with the TAPI server.
*Notices:
To change current PINs and passwords, click on Edit PIN and password.
A coloured bar under the entry field shows the security level of the password (red = low level, green = high level).
Passwords with a low security level cannot be saved.
*Caution:
A high level does not automatically indicate a secure password. This can also be achieved by name and date of birth in connection with special characters. However, names and dates of birth should not be used for passwords.
•To create a secure password you can consult, for example, the guidelines of the German Federal Office for Information Security (BSI, in German).
Visible PINs and passwords are a security risk.
•After entering, select Hide PIN and password.
Restart TAPI server | Restart
Restarts the TAPI server.
Use PBX Call Assist
Requirements:
•PBX Call Assist function enabled (optional, see Activation)
PBX Call Assist is a CTI software available from Auerswald. Its use must be switched on in the PBX.
All available TAPI lines are administrated by the corresponding server software UCServer. Other TAPI applications cannot be used in parallel.
Further steps:
•Install the server and client software. You will find the installation files on the Internet (see Auerswald Service Portal).