Transferring with Announcement
In order to transfer a call, first initiate a query call, announce the call and then connect both communication partners.
Requirements:
•Initiated query call
•To connect two external communication partners, the following is required: Authorisation Transfer of external calls to external assigned to the subscriber
•Hang up the receiver during a query call.
Both communication partners are connected with each other.
Note: Some ISDN phones may ring after hanging up the receiver and you may then be reconnected with your first communication partner after picking up the receiver. Use the manual for the phone to check whether the Transfer at a PBX function has been enabled. If this has not been done, do this subsequently.•If you want to initiate a new call immediately after the transfer, proceed during the query call as follows.
1) Press the Flash key or the Query key.
2) Dial 4.
Both communication partners are connected with each other.
You will hear the internal dial tone.
3) Initiate a new call.
Important: A call transferred between two external communication partners is limited to a defined period of time. This is a security feature, since the transfer of the time announcement or of the weather forecast made by mistake, for instance, would lead to a very long call.Note: You will be charged the fees for a transferred call by your network provider.Note: You can also use this function on analogue phones, where it can be performed via the T-Net function key/menu (optional, see manual for the phone).Note: On some ISDN phones, this function can be called via an existing function key or via the menu (optional, see manual for the phone).