Management LCR Tables
Proceed as follows:
Using the Configuration Manager (Routage > Soft-LCR 4.0 > LCR-Tables > Configurer)
Jour
Requirements:
For use of holidays: holidays created and LCR active
Using the Configuration Manager (Fonctions > Calendrier)
Weekdays when dialling is to be carried out using the corresponding provider.
Heure
Time point starting on the corresponding Jour when the dial attempt is to be carried out via the corresponding provider (select Nouvelle).
Fournisseur
Aucun LCR
The dial attempt is initiated without a provider area code.
Émettre tonalité occupée
The dial attempt is ended and a busy signal is issued.
Provider name: The dial attempt is initiated using the area code entered under Routage > Soft-LCR 4.0 > Providers.
*Note: During the dial attempt, if the selected provider under Fournisseur principal is busy, the selected provider under 1st fallback provider is attempted, etc. If still no connection is established during the dial with the 2nd fallback provider, a busy signal is issued.
Prix par connexion
Proceed as follows:
Separately for main provider, 1st and 2nd fallback provider.
Indicates the fee a provider charges for the establishment of a connection, based on the currency entered in the PBX (Fonctions > Crédits de communication).
Prix par minute
Proceed as follows:
Separately for main provider, 1st and 2nd fallback provider
The PBX uses Prix par minute for internal calculations and display purposes during calls that are initiated by an LCR subscriber and perhaps a Call Through user and routed via the corresponding provider.
The Prix par minute refers to the currency entered in the PBX (Fonctions > Crédits de communication under Coûts).
Cadencement 1re horloge
Proceed as follows:
Separately for main provider, 1st and 2nd fallback provider
Seconds the provider assigns the first meter pulse after the connection has been established (after CONNECT).
*Note: This meter pulse is fully billed by the provider even if the call is ended before this time has elapsed.
Mesure suivante
Proceed as follows:
Separately for main provider, 1st and 2nd fallback provider
Charge pulse time unit used to bill a call after the first metering pulse.
*Note: For second pulses of differing lengths, enter the most unfavourable meter pulse.
*Note: The provider bills each started meter pulse in full.
Nouvelle
Adds a new LCR table to the list.
Supprimer
Deletes the entries marked in the list.