Displays the relay to be configured.

Name of the relay as under Relays (actuators).

Displays the selected operating mode.

Available relays can be toggled without affecting the PBX. After a reboot of the PBX the last identifiable state of the relay is restored.

Swichtes off relays with the operating modes Light, Door opener, Alarm and PC relay after the specified switching duration. When switched off, the hold time of the relay will be used. The PBX does not actively switch off the relay.

Specifies after how many seconds the relay will be switched off. Possible entries: 0 to 6000 (0 only for manual relays). It can only be switched off after the set switching duration when off control is enabled.

Specifies how many milliseconds the relay is held. Possible entries: 10 to 10000. The hold time is used for the relays whose switching off cannot be controlled anymore. A sufficiently long enought hold time will make sense. A relay is only held for the set time when off control is disabled.

Waiting time in milliseconds before the PBX sends DTMF sequences to the door terminal again. Possible entries: 0 to 10000 milliseconds. Time settings for receiving DTMF sequences again are to be made in accordance with the instructions of the connected devices.

Settings of the required DTMF sequences in order to switch on an analogue relay. Possible entries: Digits and the characters * and # and the comma ',' character as a pause of half a second.

Settings of the required DTMF sequences in order to switch off an analogue relay. Possible entries: Digits and the characters * and # and the comma ',' character as a pause of half a second.

The dialogue for the configuration is closed, already created data is discarded.

The dialogue for the configuration is closed, already created data is saved.