Help > Using the web interface > Telephones > Status
Status
Telephone type
Select the telephone type or DECT base you want to display/configure.
*Further help under Hardware
Name
Freely selectable name. This name is used to identify the device within the PBX.
*Further help under Hardware
MAC address
The MAC address of the device is used for identification. For all transactions between device and PBX, the PBX must be able to identify the MAC address of the device so that the device can be matched to provisioning data.
The MAC address of a device can be found as follows:
•Retrieving from a client certificate sent by the device
•Reading with a bar code scanner enabled and connected to the computer (e.g. via a USB interface)
•Reading e.g. on the menu of the phone or on a label
*Note: If the MAC address was determined via automatic provisioning or entered by yourselves, the device will be provided with provisioning data during its first boot process.
*Further help under Hardware
Manufacturer
The manufacturer name of the device. If automatic provisioning is enabled, the name is entered by the PBX as long as the device provides this information.
*Further help under Hardware
Model
The model name of the device. If automatic provisioning is enabled, the name is entered by the PBX as long as the device provides this information.
*Further help under Hardware
Version
The currently used firmware version for this device. If automatic provisioning is enabled, the name is entered by the PBX as long as the device provides this information.
*Further help under Hardware
User
---
No user has been assigned to this telephone.
[Phone number] | [name]
A user has been assigned to this telephone. The user can be permanently assigned (owner) or not.
--- [(Phone number] | [name)]
A temporarily assigned user (owner) is logged out at this time.
*Further help under Hardware
Status
Display of registration (IP phones), connection (analogue phones) and provisioning of devices (telephones, DECT bases, door terminals) and (not yet) assigned devices by different symbols. These are explained in the following.
*Note: When calling the page, the current status is displayed first and is then automatically refreshed after 30 seconds.
*Note: Not all status information can be updated automatically, see following sections.
*Further help under Hardware
Additional information
Information about the individual devices (IP/MAC address, model name, firmware version, status).
*Further help under Hardware