Analogue settings
Proceed as follows:
•Separately for subscribers
•Using the Configuration Manager
•Subscriber-related (Abonnés (Abo) > Abonné)
Abonnés (Abo)
Select the subscriber you want to display/configure.
•Function-related (Configurer > Abonnés (Abo))
Surmodulé par le biais du profil dans la configuration
Opens the configuration of the single function for all subscribers.
Important: The settings done are only valid on the condition that they are not overridden by a profile. The simultaneous display takes place only on page Subscriber (scr.) > Abonnés (Abo) under faculté libre.
Notices:(non commandé par le profil): In the displayed configuration, the function is overridden by the displayed setting. Configuration via the Configuration Manager (Subscriber (scr.) > Profiles> ...)
not overridden by a profile: The function is currently not overridden by a profile.
(not profile-controlled): The function cannot be controlled with a profile.
Requirement:
•Subscriber is an analogue end device
Infos CLIP
Requirements:
•Subscriber is a CLIP-capable analogue phone
The phone number information (if transmitted) is displayed on the display of the phone.
Infos CLIP étendues
Requirements:
•Subscriber is a CLIP-capable analogue phone
In the caller list of the phone date and time of missed calls are recorded. The name can be displayed instead of or in addition to the phone number.
Note: For some end devices, extended CLIP information can cause problems and should therefore be disabled.Durée du flashing (décrocher-raccrocher)
Hook flash timing enables the PBX to detect a flash signal from the subscriber in question.
For this to work, the hook flash timing must correspond with the time that is configured for the flash signal on the analogue end device (see the phone manual).
Note: DTMF phones that execute various functions using the T-Net function key/menu use a flash of 300 ms to do this. In order to also use these functions on the PBX, the same time as the hook flash timing must be configured on the PBX. Usually, there is an additional flash button available on this phone that must also be configured with this value (see the phone manual).Note: Note that the PBX does not detect a receiver being hanged up until after hook flash timing is finished.Sonnerie pour les appels internes
The ringtone specifies which sequence of sounds is used to signal internal calls to internal subscribers on the PBX.
Duration of the 1st ringing signal
Specifies how many milliseconds the 1st ring signal lasts. With this setting, the CLIP function of analogue phones can be influenced under certain circumstances.
0 ms
The 1st ringing signal lasts 1000 milliseconds. Default value for UK location.
1000 ms
The 1st ringing signal lasts 1000 milliseconds. Default value for other locations.