NET module
Obtain IP address automatically (DHCP client)
The NET module obtains its IP address automatically from a DHCP server.
Assigning IP address manually
Requirements:
•Disabled DHCP client
IP address
IPv4 address in the range 0 - 255 (example: 192.168.0.240).
Subnet mask
IPv4 address of the subnet mask in the range 0 - 255 (example: 255.255.255.0).
MAC address
Specific and unique hardware address of the NET module.
Opens the IPv6 configuration.
IPv6 Mode
If IPv6 is switched on, an IP address complying with version 6 of the Internet protocol can be assigned to the NET module. Thanks to the greater length of IPv6 addresses (eight blocks with four digits each, example: 3001:00FF:ABC0:0EAC:0001:0000:0000:000F), IPv6 offers a greater number of available IP addresses than version 4 of the Internet protocol (IPv4).
deactivated
Switches off the use of IPv6 addresses.
SLAAC
Automatically assigns an IPv6 address to the NET module.
static
Automatically assigns a user-defined IPv6 address to the NET module.
Note: If IPv6 has been disabled for the PBX, IPv6 can also not be enabled for any modules. If, in the reverse, IPv6 has been enabled for the PBX, it is also enabled automatically for all modules and cannot be disabled.
IPv6 address
Requirements:
•IPv6 modestatic selected
IPv6 address
IPv6 address of the NET module.
Prefix length
Requirements:
•IPv6 modestatic selected
Prefix length
Prefix length in the range 1 up to 128. The prefix specifies to which subnet the IPv6 address belongs.
IPv6 gateway
Requirements:
•IPv6 modestatic selected
IPv6 gateway
Possible entries: Digits, characters and :.